CP2-HB095-GA1-TG30

3M™ CP2 Press-Fit Header 2 mm Type B, 95, 110 and 125 Signal Contacts • • • • • • • • • • CP2 Series 25 mm basic system unit 38, 44 and 50 mm module 2 mm grid spacing allows for high signal density at low cost “Eye of the Needle” compliant pin press-fit design helps reduce manufacturing time and cost Three contact mating levels for Early Mate Late Break or “Hot Swap” applications help reduce manufacturing time and cost Feed through termination available for midplane applications Additional grounding rows available for improved ground bounce and EMI immunity Mates with 5 row 3M™ HSHM, UHM and CP2 Sockets End to end stackable with 5 row 3M™ HSHM, HSM, HM, and CP2 Headers See the Regulatory Information Appendix (RIA) in the “RoHS compliance” section of www.3Mconnectors.com for compliance information. (RIA E1 & C1 apply) Date Modified: July 16, 2015  TS-2267-C Sheet 1 of 7 Physical Insulation: Material: Glass Filled Polyester (PBT) Flammability: UL94V-0 Contact: Material: Copper Alloy Plating: See Ordering Information Mechanical Mating Force: Withdrawl Force: Mating and Un-mating Operations: Application: ≤ 0.75N/PIN ≥ 0.15N/PIN 200 for KR plating This module is not suitable for stand-alone use. (Refer to IEC-61076-4-101) Electrical Current Rating: Contact Resistance: Insulation Resistance: Test Voltage: 1.0 Amperes at 70°C with all contacts powered ≤ 20 mΩ ≥ 10,000 MΩ 750 VACRMS Environmental Temperature Ratings: -55°C to +125°C PCB Data Recommended PCB Plated Through Hole: Drill Hole Diameter: Hole platings: PCB thickness: Press-In Force: Retention Force: 3 Electronics Materials Solutions Division Interconnect Solutions http://www.3Mconnectors.com ϴ 0.6±0.05 mm Ө 0.7±0.02 mm Cu 25~50 μm, Sn