RN134-I/RM

RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 WiFly GSX Super Module “SuRF Board” Features • UART interface with RS232 and TTL signaling • Through hole board simplifies system integration • Accepts 3-12VDC • Status LEDs to show network status and data transfer • Ultra-low power - 4uA sleep, 50mA Rx, 210mA Tx (max) • High throughput, 1Mbps sustained data rate with TCP/IP and WPA2 Description • Through hole design with mounting posts • Jumpers for setting adhoc mode • On board ceramic chip antenna and U.FL connector for external antenna • 10 general purpose digital I/O • 8 analog sensor interfaces The RN-134 “SuRF” board is field ready, WiFi certified 802.11 b/g solution. The SuRF board has the flexibility to connect directly to a standard RS232 interface or through the TTL UART interface to embedded systems. The status LEDs and jumpers enable rapid prototyping and integrating into existing systems. • Real-time clock for wakeup and time stamping • On board ECOS -OS, TCP/IP stacks • Wi-Fi Alliance certified for WPA2-PSK • FCC / CE/ ICS certified and RoHS compliant. Applications • Wireless serial connections • Remote sensors • Telemetry • Security • Industrial sensors and controls • Home Automation The RN-134 is built upon Roving Networks RN-131 WiFly-GSX module. The WiFly GSX module incorporates a 2.4GHz radio, processor, Full TCP/IP stack, real-time clock, FTP, DHCP, DNS and web server. The RN-131G is the smallest, lowest power 802.11 b/g module available. The module supports adhoc and infrastructure networking. In the simplest configuration the hardware only requires four connections (PWR, TX, RX, GND). In cases where power is available on the RS232 DB9 connector of your application, the RN134 can be directly wired to create an instant serial to Wifi network link. Additionally, the analog sensor interface provides direct connections to send temperature, acceleration and other analog data without requiring additional hardware. The WiFly GSX module is programmed and controlled with a simple ASCII command language. Once the WiFly GSX is setup it can scan to find an access point, associate, authenticate and connect over any WifI network. 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 1 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 Overview • Host Data Rate up to 1 Mbps for UART interface, 230400 for RS232 interface. • Intelligent, built-in power management with programmable wakeup • Powered from regulated 3.3-3.7V source or 2.0-3.0V batteries • Real time clock for time stamping, auto-sleep and auto-wakeup modes • Configuration over WiFi or UART using simple ASCII commands • Over the air firmware upgrade via FTP • Secure WiFi authentication: WEP-64, WEP-128, WPA, WPA2 • Built in networking applications DHCP, DNS, ARP, ICMP UDP, Telnet, FTP • 802.11 power save and roaming functions Environmental Conditions Parameter Temperature Range (Operating) Temperature Range (Storage) Relative Humidity (Operating) Relative Humidity (Storage) Value o o -30 C ~ 85 C o o -30 C ~ 85 C ≤90% ≤90% Electrical Characteristics Supply Voltage Supply Voltage VDD UART interface Min 3.0 3.0 Power consumption Sleep Standby (doze) Connected (idle, RX) Connected (TX) Typ. 3.3 3.3 4 15 40 140 - Max. 12 3.3 212 Unit V V uA mA mA mA Analog Sensor Inputs Parameter Value Sense 0,1,2,3 wakeup detect threshold 500mV AD sense 0-7 measurement range 0-400mV Precision 14 bits = 12uV Accuracy 5% un-calibrated, .01% calibrated Minimum conversion time 35uS (5kHz over wifi ) Sensor Power (pin 33) output resistance 3.3V 10 ohms, max current = 50mA 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 2 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 Radio Characteristics Parameter Frequency Modulation Channel intervals Specifications 2402 ~ 2480MHz 802.11b compatibility : DSSS(CCK-11, CCK-5.5, DQPSK-2, DBPSK-1) 802.11g : OFDM (default) 5MHz Channels Transmission rate (over the air) 1 - 14 1 – 11Mbps for 802.11b / 6 – 54Mbps for 802.11g Receive sensitivity -85dBm typ. Output level (Class1) +18dBm Maximum RF input to U.FL connector 10 dBm 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 3 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 Board Description 1 2 3 4 5 6 7 8 UART Interface TTL signals Power 2 4 6 8 10 5-12 VDC GND RX - input to SuRF board TX - output from SuRF board 1 3 5 7 9 Sensors 12 11 10 9 8 7 6 5 4 3 2 1 (Note: the lables on the board for RX and TX are incorrect) PIN 1 2 3 4 5 6 7 8 9 10 11 12 Evaluation Board Connector Description 3.3 VDC GND RXDB TXDB RSTB CTSB PIO4 PIO5 PIO6 PIO7 PIO8 Reset WARNING: Sensors must not be driven with more than 1.2 VDC or permanent damage will occur PIN 1 2 3 4 5 6 7 8 Description Sensor PWR Resistor network to Sensor-4 Resistor network to Sensor-5 Sensor-7 (1.2 VDC) Sensor-4 (1.2 VDC) Sensor-5 (1.2 VDC) Sensor-6 (1.2 VDC) GND RS232 Interface 10 9 8 7 6 5 4 3 2 1 RX - input to SuRF board TX - output from SuRF board PIN 1 2 3 4 5 6 7 8 9 10 Description No connect RX TX No connect GND No connect RTS CTS 5 – 12 VDC No connect 1 2 3 4 Jumper Block 1 - 4 1) 2) 3) 4) Adhoc mode & Factory Reset Config 1 Config 2 Config 3 LED Indicators Condition ON solid Blue LED Yellow LED Not Associated Slow blink No Power Green LED Connected over TCP Power On Fast blink OFF Red LED Associated, No Internet Associated, Internet OK Rx/Tx data transfer No IP address IP address OK 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 4 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 Physical Dimensions 51.2 mm 4.9 mm 26.6 mm 12.8 mm Top view 51.2 mm 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 5 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 WiFly GSX Super Module “SuRF Board” Features • UART interface with RS232 and TTL signaling • Through hole board simplifies system integration • Accepts 3-12VDC • Status LEDs to show network status and data transfer • Ultra-low power - 4uA sleep, 50mA Rx, 210mA Tx (max) • High throughput, 1Mbps sustained data rate with TCP/IP and WPA2 Description • Through hole design with mounting posts • Jumpers for setting adhoc mode • On board ceramic chip antenna and U.FL connector for external antenna • 10 general purpose digital I/O • 8 analog sensor interfaces The RN-134 “SuRF” board is field ready, WiFi certified 802.11 b/g solution. The SuRF board has the flexibility to connect directly to a standard RS232 interface or through the TTL UART interface to embedded systems. The status LEDs and jumpers enable rapid prototyping and integrating into existing systems. • Real-time clock for wakeup and time stamping • On board ECOS -OS, TCP/IP stacks • Wi-Fi Alliance certified for WPA2-PSK • FCC / CE/ ICS certified and RoHS compliant. Applications • Wireless serial connections • Remote sensors • Telemetry • Security • Industrial sensors and controls • Home Automation The RN-134 is built upon Roving Networks RN-131 WiFly-GSX module. The WiFly GSX module incorporates a 2.4GHz radio, processor, Full TCP/IP stack, real-time clock, FTP, DHCP, DNS and web server. The RN-131G is the smallest, lowest power 802.11 b/g module available. The module supports adhoc and infrastructure networking. In the simplest configuration the hardware only requires four connections (PWR, TX, RX, GND). In cases where power is available on the RS232 DB9 connector of your application, the RN134 can be directly wired to create an instant serial to Wifi network link. Additionally, the analog sensor interface provides direct connections to send temperature, acceleration and other analog data without requiring additional hardware. The WiFly GSX module is programmed and controlled with a simple ASCII command language. Once the WiFly GSX is setup it can scan to find an access point, associate, authenticate and connect over any WifI network. 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 1 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 6. Having this jumper on at power up also arms the restore factory reset function. After power up, if jumper 1 is toggled on and off five times while the module the configuration will be RESTORED to the initial settings. This is very useful in cases where the module is mis-configured and no is long responding to commands. Compliance Information FCC ID U3O-G2M5477 Part 15.247 IC (canada) RSS-210 CE EU ID # 0681 REG U9M20901-1000-C RADIO EN 300328 V1.7.1 (10/2006) EMC EN 301489-1 V1.8.1 (04/2008), EN 301489-17 V1.3.2 (04/2008) SAFETY EN 60950-1:2001+A11:2004 RoHs Compliant Ordering Information Part Number RN-134 RN-131G RN-131G-EVAL RN-UFL-SMA6 RN-SMA4-RP Description With chip antenna and U.FL jack. Standard firmware version WiFly-GSX 802.11 b/g surface mount module Development Kit (Includes the RN-134 module) 6 inch cable with U.FL connector on one end and SMA on the other 4” external antenna with reverse polarity SMA connector. Used with RN-UFL-SMA6 For other configurations, contact Roving Networks directly. Visit http://www.rovingnetworks.com for current pricing and a list of distributors carrying our products. Copyright © 2009 Roving Networks. All rights reserved. Roving Networks reserves the right to make corrections, modifications, and other changes to its products, documentation and services at any time. Customers should obtain the latest relevant information before placing orders and should verify that such information is current and complete. Roving Networks assumes no liability for applications assistance or customer product design. Customers are responsible for their products and applications using Roving Networks components. To minimize the risks associated with customer products and applications, customers should provide adequate design and operating safeguards. 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 7 ~ RN-134 www.rovingnetworks.com rn-134-ds v1.1 12/14/2009 Roving Networks products are not authorized for use in safety-critical applications (such as life support) where a failure of the Roving Networks product would reasonably be expected to cause severe personal injury or death, unless officers of the parties have executed an agreement specifically governing such use. All other trademarks are property of their respective owners. 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com ~ page 8 ~