NLP65-9915J

POWER NLP65-M Single, Dual and Triple output Data Sheet Total Power: 65 W Input Voltage: 85-264 VAC # of Outputs: Single, Dual, Triple Special Features ƒƒ 85 VAC to 264 VAC universal input range ƒƒ Harmonic current correction as standard ƒƒ Maximum component height 1.26 inches ƒƒ UL, CSA and VDE safety approvals ƒƒ Overvoltage and short circuit protection ƒƒ 5 x 3 x 1.26 inch (127.0 x 76.2 x 32mm) footprint ƒƒ Available RoHS compliant ƒƒ 2 years warranty Safety ƒƒ UL60601-1/CAN/CSA-C22.2 No. 60601-1-M90 ƒƒ VDE License No. 121949 under | EN60601-1/IEC60601-1 Electrical Specifications Input Input voltage range: Universal input (see Note 2) Input frequency range: 85 - 264 Vac 47-63 Hz Input current: (cold start) 120 Vac 230 Vac 17 A max. 32 A max Safety ground leakage current: 264 Vac, 60 Hz 95 μA Input current: 120 Vac 230 Vac 1.05 A rms 0.51 A rms Input fuse: 250 Vac F 5 A Output Output power: Natural convection Total regulation: (line and load) 65 W max. See table Rise time: At turn-on 1.0 s, max Transient response: Main output 25% step at 0.1 A/μs 5.0% max. dev., 1ms recovery to 1.0% Temperature coefficient: ± 0.02%/°C Overvoltage protection: Main outputs 125%, ± 10% Short circuit protection: Cyclic operation Yes NLP65-M Series Data Sheet All specifications are typical at nominal input, full load at 25°C unless otherwise stated. EMC Charateristics Conducted emissions: EN55022, FCC part 15 Level A Radiated emissions: EN55022, FCC part 15 Level A ESD air: EN61000-4-2, level 3 Perf. criteria 1 ESD contact: EN61000-4-2, level 4 Perf. criteria 1 Surge: EN61000-4-5, level 3 Perf. criteria 1 Fast transients: EN61000-4-4, level 3 Perf. criteria 1 Radiated immunity: EN61000-4-3, level 3 Perf. criteria 2 Conducted immunity: EN61000-4-6, level 3 Perf. criteria 2 Hold-up time: 120 Vac, 60 Hz 16 ms @ 65 W Efficiency: 120 Vac, 65 W 72% typical Isolation voltage: Input/output Input/chassis 4000 Vac 1500 Vac Switching frequency: Fixed 100 kHz, ± 5 kHz Approvals and standards: EN60601-1, IEC60601-1 Weight: 283 g (10 oz) MTBF demonstrated: MIL-HDBK-217F General Specifications 150,000 hours Environmental Specifications Thermal performance: Operating (See derating curve) 0°C to +70°C Non-operating -40°C to +85°C 0°C to 50°C, ambient, convection cooled 65 W 50°C - 70°C ambient, convection cooled Derate to 50% load Peak (0°C to 50°C, 60 s) See table Relative humidity: Non-condensing 5 to 95% RH Altitude: Operating 10,000 feet max. Non-operating 30,000 feet max. Vibration (See Note 5): 5-500 Hz 2.4 G rms approx. Shock per MIL-STD-810E 516.4 Part IV 75W DERATING CURVE Output Power(Walts) 20 CFM FORCED AIR COOLING 65W NATURAL CONVECTION COOLING 38W 32W 0°C 10°C 20°C 30°C 40°C 50°C 60°C 70°C NLP65-M Series Data Sheet Ordering Information Output Current Output Voltage Max(1) Peak Fan(10) +5 V 7A 9.1 A 8A Ripple(4) Total Regulation(6) Model Number (11, 12) 50 mV ± 2.0% NLP65-9908J +12 V 2.5 A 3.3 A 3A 150 mV ± 5.0% –12 V 0.5 A 0.81 A 1A 120 mV ± 5.0% +5 V 7A 9.1 A 8A 50 mV ± 2.0% +24 V 2A 2.6 A 2A 240 mV ± 5.0% +5 V 7A 9.1 A 8A 50 mV ± 2.0% +12 V 2.5 A 3.3 A 3A 150 mV ± 5.0% +12 V 5.4 A 7A 6.5 A 120 mV ± 2.0% NLP65-9920J NLP65-9929J NLP65-9912J +15 V 4.4 A 5.7 A 5.3 A 150 mV ± 2.0% NLP65-9915J +24 V 2.7 A 3.5 A 3.5 A 240 mV ± 2.0% NLP65-9924J Notes 1. Natural convection cooling. Models NLP65-9929J, and NLP65-9908J must not exceed 62.5 Watts continuous output power with natural convection. Model NLP65-9920J not to exceed 65 Watts continuous output power with natural convection. 2. When the input voltage is less than 90 Vac the operating temperature range is 0°C to +40°C. The ripple and regulation specifications may not be met. 3. Peak output current lasting less than 60 seconds with duty cycle less than 5%. During peak loading, output voltage may exceed total regulation limits. 4. Figure is peak-to-peak for convection power rating. Output noise measurements are made across a 20 MHz bandwidth using a 6 inch twisted pair, terminated with a 10 μF electrolytic capacitor and a 0.1 μF ceramic capacitor. 5. Three orthogonal axes, random vibration 10 minutes for each axes, 2.4 G rms 5 Hz to 500 Hz. 6. To maintain stated regulation then: For single output units: I ≥ 0.2 A I max. For multiple output units: 0.25 ≤ I(A)/I(B) ≤ 5, for I(A) ≥ 0.2 A I(A) max. 7. For optimum reliability, no part of the heatsink should exceed 120°C, and no semiconductor case temperature should exceed 130°C. 8. CAUTION: Allow a minimum of 1 second after disconnecting line power when making thermal measurements. 9. This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. 10. Maximum continuous output power for all multiple output models must not exceed 75 Watts with 20 CFM forced air cooling at 50°C. 11. The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. 12. NOTICE: Some models do not support all options. Please contact your local Artesyn Embedded Technologies representative or use the on-line model number search tool at http://www.artesyn.com/power to find a suitable alternative. NLP65-M Series Data Sheet Mechanical Drawings 5.00 (127.00) 4.550 (115.57) 0.225 (5.715) J1 3 N J3 1 1 L 3.00 (76.20) 6 T 1 T1 J2 2.550 (64.770) C19 Mounting Hole Diameter 0.156 (4.00) ALL DIMENSIONSIN INCHES (mm) MAXIMUM COMPONENT HEIGHT 1.26 (32.00) TOLERANCE: .xxx 0.005" .xx 0.02" Input Pin Connections J1 Pin 1 AC Line Pin 2 No Pin Pin 3 AC Neutral J2 Pin 1 Safety Ground Output Pin Connections J3 SINGLE DUAL TRIPLE Pin 1 No Connection V (B) V (B) Pin 2 V (A) V (A) V (A) Pin 3 V (A) V (A) V (A) Pin 4 Return Return Return Pin 5 Return Return Return Pin 6 No Connection No Pin V (C) Input and Output Connectors Mating Connectors AC (J1) Molex 26-60-4030 type or equivalent Molex 09-50-3031 or equivalent with Molex 08-52-0113 or equivalent crimp terminals DC (J3) Molex 26-60-4060 or equivalent Molex 09-50-3061 with Molex 2478 phosphor bronze crimp terminals or equivalent. WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 2900 S.Diablo Way Tempe, AZ 85282 USA +1 888 412 7832 Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom +44 (0) 1384 842 211 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong +852 2176 3333 While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. © 2014 Artesyn Embedded Technologies, Inc. www.artesyn.com For more information: www.artesyn.com/power For support: productsupport.ep@artesyn.com NLP65-M Series-DS 06.26.14