6N138M-V

8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Schematic Features • High current transfer ratio–2000% typical • High isolation voltage between input and output (Viso=5000 Vrms ) • Guaranteed performance from 0°C to 70°C • Pb free and RoHS compliant. • UL approved (No. 214129) • VDE approved (No. 132249) • SEMKO approved • NEMKO approved • DEMKO approved • FIMKO approved •CSA approved (No. 2037145) 1 8 2 7 3 6 4 5 Pin Configuration 1. No Connection 2. Anode 3. Cathode 4. No Connection 5. Gnd 6. Vout 7. VB 8. Vcc Description The 6N138 and 6N139 devices each consists of an infrared emitting diode, optically coupled to a high gain split Darlington photo detector. They provide extremely high current transfer ratio between input and output, with access to a base terminal to adjust the gain bandwidth.These devices are packaged in an 8-pin DIP package and available in wide-lead spacing and SMD options. Applications • Digital logic ground isolation • RS-232C line receiver • Low input current line receiver • Microprocessor bus isolation • Current loop receiver 1 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No: DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Absolute Maximum Ratings (Ta=25℃) Parameter Symbol Rating Unit IF 20 mA IFP 40 mA IFtrans 1 A Reverse voltage VR 5 V Power dissipation PIN 45 mW Power dissipation PO 100 mW Output current IO 60 mA Emitter-Base Reverse Voltage VER 0.5 V Forward current Input Output Peak forward current (50% duty, 1ms P.W) Peak transient current (≤1µs P.W,300pps) 6N138 6N139 6N138 6N139 VCC -0.5 to 7 -0.5 to 18 -0.5 to 7 -0.5 to 18 VISO 5000 V rms Operating temperature TOPR -40 ~ +85 °C Storage Temperature TSTG -55 ~ +125 °C TSOL 260 °C Output voltage Supply voltage Isolation voltage *1 Soldering temperature *2 VO V V Notes: *1 AC for 1 minute, R.H.= 40 ~ 60% R.H. In this test, pins 1, 2, 3, 4 are shorted together, and pins 5, 6, 7, 8 are shorted together. *2 For 10 seconds 2 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Electrical Characteristics (TA=0 to 70°C unless specified otherwise) Input Symbol Min. Typ. Max. Unit Condition Forward voltage VF - 1.3 1.7 V IF = 1.6mA Reverse Voltage VR 5.0 - - V IR = 10µA, TA=25°C ∆VF/∆TA - -1.8 - mV/°C IF =1.6mA Min Typ. Max. Unit Condition - 0.01 100 - - 250 µA IF=0mA, VO=VCC=18V ICCL - 0.6 1.5 mA IF=1.6mA, VO=Open, VCC=18V ICCH - 0.05 10 µA IF=0mA, VO=Open, VCC=18V Parameter Temperature coefficient of forward voltage Output Parameter Logic High 6N138 Output Current 6N139 Logic Low 6N138 Supply Current 6N139 Logic High 6N138 Supply Current 6N139 Symbol IOH Transfer Characteristics (Ta=0 to 70°C unless specified otherwise, Vcc=4.5V) Parameter Current Transfer Ratio Symbol CTR Max. 400 2500 - 500 2000 - 300 2000 - - 0.05 0.4 - 0.09 0.4 - 0.12 0.4 - 0.17 0.4 - 0.06 0.4 Unit VOL Condition IF = 0.5mA, VO = 0.4V, VCC=4.5V % 6N139 6N138 3 Typ. 6N139 6N138 Logic Low Output Voltage Min V IF = 1.6mA, VO = 0.4V, VCC=4.5V IF = 0.5mA, IO = 2mA, VCC=4.5V IF = 1.6mA, IO = 8mA, VCC=4.5V IF = 5mA, IO = 15mA, VCC=4.5V IF = 12mA, IO = 24mA, VCC=4.5V IF = 1.6mA, IO = 4.8mA, VCC=4.5V Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Switching Characteristics Parameter Propagatio n Delay Time to Logic Low (Fig. 13) Symbol (Ta=0 to 70°C unless specified otherwise, Vcc=5V) Min Typ. Max. Unit - 5 25 IF = 0.5mA , RL=4.7kΩ, TA=25°C - - 30 IF = 0.5mA , RL=4.7kΩ - 0.2 1 IF = 12mA , RL=270Ω, TA=25°C - - 2 IF = 12mA , RL=270Ω - 1.4 10 IF = 1.6mA , RL=2.2kΩ, TA=25°C - - 15 IF = 1.6mA , RL=2.2kΩ - 16 60 IF = 0.5mA , RL=4.7kΩ, TA=25°C - - 90 IF = 0.5mA , RL=4.7kΩ - 1.7 7 IF = 12mA , RL=270Ω, TA=25°C - - 10 IF = 12mA , RL=270Ω - 8 35 IF = 1.6mA , RL=2.2kΩ, TA=25°C - - 6N139 TPHL µs 6N138 Propagatio n Delay Time to Logic High (Fig. 13) 6N139 TPLH µs 6N138 50 Condition IF = 1.6mA , RL=2.2kΩ Common Mode Transient Immunity at Logic High *3 (Fig. 14) CMH 1,000 - - V/µs IF = 0mA , VCM=10Vp-p, RL=2.2KΩ, TA=25°C Common Mode Transient Immunity at Logic Low *3 (Fig. 14) CML 1,000 - - V/µs IF = 1.6mA , VCM=10Vp-p, RL=2.2KΩ, TA=25°C * Typical values at Ta = 25°C 4 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Typical Electro-Optical Characteristics Curves 5 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 6 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Fig. 13 Switching Time Test Circuit and Waveform Pulse Generator Tr=5ns, Zo=50 Ω +5V IF IF RL IF Monitor Vo 0.1uF 5V VO 1.5V 0.1uF VOL Rin tPHL tPLH Fig. 14 Common Mode Transient Immunity Test Circuit and Waveform IF B +5V RL VF Vo A VFF 0.1uF VCM Note: *3 Common mode transient immunity in logic high level is the maximum tolerable (positive) dVcm/dt on the leading edge of the common mode pulse signal VCM, to assure that the output will remain in a logic high state (i.e., VO > 2.0V). Common mode transient immunity in logic low level is the maximum tolerable (negative) dVcm/dt on the trailing edge of the common mode pulse signal, VCM, to assure that the output will remain in a logic low state (i.e., VO < 0.8V). 7 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Order Information Part Number 6N13XY(Z)-V Note X Y Z V 8 = Part No. (X = 8 or 9) = Lead form option (S, S1, M or none) = Tape and reel option (TA, TB or none). = VDE (optional) Option None Description Packing quantity Standard DIP-8 45 units per tube M Wide lead bend (0.4 inch spacing) 45 units per tube S (TA) Surface mount lead form + TA tape & reel option 1000 units per reel S (TB) Surface mount lead form + TB tape & reel option 1000 units per reel S1 (TA) Surface mount lead form (low profile) + TA tape & reel option 1000 units per reel S1 (TB) Surface mount lead form (low profile) + TB tape & reel option 1000 units per reel Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Package Dimension (Dimensions in mm) Standard DIP Type Option M Type 9 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Option S Type Option S1 Type 10 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Recommended pad layout for surface mount leadform Device Marking EL 6N138 YWWV Notes EL 6N138 Y WW V 11 denotes EVERLIGHT denotes Device Number denotes 1 digit Year code denotes 2 digit Week code denotes VDE (Optional) Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Tape & Reel Packing Specifications Option TA Option TB Direction of feed from reel Direction of feed from reel Tape dimensions 12 Dimension No. A B Do D1 E F Dimension(mm) 10.4±0.1 10.0±0.1 1.5+0.1/-0 1.5±0.25/-0 1.75±0.1 7.5±0.1 Dimension No. Po P1 P2 t W K Dimension(mm) 4.0±0.1 12.0±0.1 2.0±0.05 0.4±0.05 16.0±0.3/ 4.5±0.1 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 Precautions for Use 1. Soldering Condition 1.1 (A) Maximum Body Case Temperature Profile for evaluation of Reflow Profile Note: Reference: IPC/JEDEC J-STD-020D Preheat Temperature min (Tsmin) 150 °C Temperature max (Tsmax) 200°C Time (Tsmin to Tsmax) (ts) Average ramp-up rate (Tsmax to Tp) 60-120 seconds 3 °C/second max Other Liquidus Temperature (TL) 217 °C Time above Liquidus Temperature (t L) 60-100 sec Peak Temperature (TP) 260°C Time within 5 °C of Actual Peak Temperature: TP - 5°C 30 s Ramp- Down Rate from Peak Temperature 6°C /second max. Time 25°C to peak temperature Reflow times 8 minutes max. 3 times . 13 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com DATASHEET 8 PIN DIP LOW INPUT CURRENT HIGH GAIN SPLIT DARLINGTON PHOTOCOUPLER 6N138 6N139 DISCLAIMER 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. 14 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000019 Rev.3 www.everlight.com