XC6211D32MR

XC6211 Series Preliminary High Speed LDO Regulator Low ESR Cap. Compatible, On / Off Switch July 4, 2003 Ver. 3 Low Power Consumption Dropout Voltage Output Current : 25 µA (TYP) : 60mV (IOUT=30mA) 200mV (IOUT=100mA) : 150 mA (VOUT < 1.7V) 240 mA ( VOUT ≥ 1.8V) (300mA limit) Applications Mobile phones Cordless phones and radio communication equipment Portable games Cameras, Video recorders Reference Voltage Source Battery Powered Equipment Highly Accurate : ±2% (±30mV when VOUT=1.5V) Output Voltage Range : 0.9V ~ 5.0 V (50mV Step) Low ESR capacitor compatible General Description The XC6211 series are highly accurate, low noise, CMOS LDO Voltage Regulators. Offering low output noise, high ripple rejection ratio, low dropout and very fast turn-on times, the XC6211 series is ideal for today’s cutting edge mobile phone. Internally the XC6211 includes a reference voltage source, error amplifiers, driver transistors, current limiters and phase compensators. The XC6211’s current limiters' foldback circuit also operates as a short protect for the output current limiter and the output pin. The output voltage is set by laser trimming. Voltages are selectable in 50mV steps within a range of 0.9V to 5.0V. The XC6211 series is also fully compatible with low ESR ceramic capacitors, reducing cost and improving output stability. This high level of output stability is maintained even during frequent load fluctuations, due to the excellent transient response performance and high PSRR achieved across a broad range of frequencies. The CE function allows the output of regulator to be turned off, resulting in greatly reduced power consumption. The XC6211 series is available in the SOT-23-5 package. Features Maximum Output Current : 150 mA (VOUT < 1.7V) 240 mA ( VOUT ≥ 1.8V) (300mA limit) Dropout Voltage Operating Voltage Range Output Voltage Range Highly Accurate Low Power Consumption Standby Current High Ripple Rejection Operating Temperature Range Low ESR Capacitor Compatible Ultra Small Packages : 200mV (IOUT=100mA) : 2.0V ~ 6.0V : 0.9V ~ 5.0V (50mV Step) : ±2% (VOUT>1.5V) : ±30mV (VOUT≤1.5V) : 25 µA (TYP.) : Less than 0.1µA (TYP.) : 65dB (10kHz) : -40OC ~ +85OC : Ceramic capacitor : SOT-23-5 Typical Applications 1 CE VIN 5 2 VSS CIN 1µF 3 NC VOUT 4 CL 1µF 1 XC6211 Series Preliminary High Speed LDO Regulator Low ESR Cap. Compatible, On / Off Switch Pin Configuration VIN 5 VOUT 4 Pin Assignment PIN NUMBER PIN NAME CE VSS NC VOUT1 VIN FUNCTION On/Off Control 1 Ground No Connection Output 1 Power Input SOT-25 1 2 1 CE 2 VSS 3 NC 3 4 5 SOT-23-5 (TOP VIEW) Block Diagram VIN CE ON/OFF Control each circuit Current Limit VOUT R2 R1 VSS Voltage Reference 2 XC6211 Series Preliminary Product Classification High Speed LDO Regulator Low ESR Cap. Compatible, On / Off Switch Selection Guide The following options for the CE pin logic and internal pull-up/down are available: Active 'High' + no pull-down resistor built-in (standard) Active 'High' + 2.0MΩ pull-down resistor built-in (semi-custom) Active 'Low' + no pull-up resistor built-in (semi-custom) Active 'Low' + 2.0MΩ pull-up resistor built-in (semi-custom) Note: *With the pull-up resistor or pull-down resistor built-in types, the supply current during operation will increase by VIN / 2.0M Ω (TYP.) Ordering Information DESIGNATOR XC6211123456 SYMBOL CE Pin Logic : DESCRIPTION Active 'High' (pull-down resistor built in) Active 'High' (no pull-down resistor built in) Active 'Low' (pull-up resistor built in) Active 'Low' (no pull-up resistor built in) Output Voltage : e.g. 2=3, 3=0, ⇒ 3.0V Output Voltage: 100mV increments, ±2% accuracy e.g. 2=2, 3=8, 4=2 ⇒ 2.80V, ±2% Output Voltage : 50mV increments, ±2% accuracy e.g. 2=2, 3=8, 4=A ⇒ 2.85V Package Type : SOT-25 (SOT-23-5) Device Orientation : Embossed Tape : Standard Feed Embossed Tape : Reverse Feed 1 A B C D 2 3 Integer 2 4 A 5 6 M R L Absolute Maximum Rating Ta = 25OC PARAMETER Input Voltage Output Current Output Voltage CE Pin Voltage Power Dissipation Operating Ambient Temperature Storage Temperature SYMBOL VIN IOUT VOUT VCE Pd Topr Tstg RATINGS 7.0 500 VSS -0.3 ~ VIN +0.3 VSS -0.3 ~ VIN +0.3 250 -40 ~ +85 -55 ~ +125 UNITS V mA V V mW O O C C 3 XC6211 Series Preliminary Electrical Characteristics PARAMETER Output Voltage Maximum Output Current Load Regulation Dropout Voltage Supply Current Standby Current Line Regulation Input Voltage Output Voltage Temperature Characteristics Ripple Rejection Rate Current Limiter Short-circuit Current EN "High" Voltage EN "Low" Voltage EN "High" Current EN "Low" Current NOTE (NOTE 1) (NOTE 2) (NOTE 3) (NOTE 4) (NOTE 5) (NOTE 6) High Speed LDO Regulator Low ESR Cap. Compatible, On / Off Switch XC6211B Series Ta=25OC SYMBOL VOUT (E) IOUTMAX ∆VOUT Vdif1 Vdif2 IDD Istby ∆VOUT / CONDITIONS IOUT=30mA *1 1mA≤IOUT≤100mA IOUT=30mA IOUT=100mA VCE=VIN VCE=VSS VOUT(T)+1.0V≤VIN≤7.0V IOUT=30mA 2.0 IOUT=30mA -40OC≤Topr≤85OC IOUT=50mA, f=10kHz 100 65 300 50 1.60 VCE=VIN VCE=VSS -0.10 -0.10 VIN 0.25 0.10 0.10 MIN × 0.98 150 15 E-1 E-2 25 0.01 0.01 50 0.10 0.20 6.0 50 TYP VOUT(T) MAX × 1.02 UNITS CIRCUIT V mA mV mV mV µA µA %/V V ppm/ O C dB mA mA V V µA µA 1 1 1 1 2 2 1 1 4 1 1 1 2 2 2 ∆VIN ⋅ VOUT VIN ∆VOUT / ∆Topr ⋅ VOUT PSRR Ilim Ishort VCEH VCEL ICEH ICEL *1 : 150mA (VOUT